banner



How To Change Adapter Settings Windows 7


Networking > Windows seven Ethernet/Wireless Configuration (Summary)

Setting Up Wired Ethernet

Photo of Ethernet and Telephone Cord Install your Ethernet card according to the manufacturer'southward directions. Connect your network cable to the ethernet carte. Locate your Ethernet jack (information technology is typically located about your telephone jack but is slightly larger than the telephone jack) and plug in the other stop of your network cable. If in that location are several ethernet jacks, try each ane until you find the jack that is enabled. You tin examination your connection by running a network software program such as Internet Explorer.

Setting Up Wireless Ethernet

  1. Go to a location on campus where wireless networking is available. Check our coverage map for details.

  2. Install Your Wireless Ethernet Card according to the manufacturers directions.
  3. In order to obtain a secure wireless connectedness through Columbia U Secure, please use these online instructions.

    If you lot choose not to use a secure wireless connection, click Commencement, select Command Panel. Select Archetype View from the menu of the left and then double-click on the Network and Sharing Middle item. Select Manage network connections from the card on the left. Right-click on the Wireless Network Connection item and and then select Connect/Disconnect. A list of wireless access points appears. Select Columbia University and then click Connect.

Configure for DHCP


The default configuration that comes with the Operating System is the right configuration for DHCP. To cheque this:
  1. Click Start so Control Console. In one case in Control Panel select Network and Internet then from the following card click on the Network and Sharing Center item.
  2. Select Change adapter settings from the menu on the left. Right-click on the Local Area Connection item so select Properties.
  3. Select Internet Protocol Version 4 (TCP/IPv4) and click Properties. Verify that under the General tab, Obtain an IP accost automatically and Obtain DNS server address automatically are selected.

Releasing and Renewing your DHCP Lease


Your computer must have an IP (network) address advisable to your location. If y'all move your computer from ane location to some other, y'all may demand to release the current charter and request a new one.
  1. Click First and so Command Panel. One time in Control Panel select Network and Internet and so from the post-obit menu click on the Network and Sharing Centre item.
  2. Select Change adapter settings from the menu on the left. Right-click on the Local Area Connection item
  3. Click Disable to release your lease. Disabled is displayed in Local Area Connection. Double-click Local Area Connection to renew your lease. Enabled is displayed in Local Area Connectedness.

Source: http://www.columbia.edu/acis/networks/howto/enet-windows7-summary.html

Posted by: crawfordwheabion.blogspot.com

0 Response to "How To Change Adapter Settings Windows 7"

Post a Comment

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel